Leeson FHP Series Chassis Mount Variable Speed Drives Manuel d'utilisateur télécharger pdf (Page 25)

15Installation

• It is recommended that the drive be oriented with the

chassis vertical for best heat dissipation. Horizontal

mounting, while acceptable, may require some thermal

derating.

• Six 0.19-inch (5 mm) wide slots accept #8 pan head

screws. Fasten either the large base or narrow flange of

the chassis to the subplate.

• Drive components are sensitive to electrostatic fields.

Avoid direct contact with the circuit board. Hold the drive

by the chassis only.

Mounting

Warning

DO NOT install, rewire, or remove this control with

input power applied. Doing so may cause fire or

serious injury. Make sure that you read and

understand the Safety Warnings before attempting

installation.

NOTE: Horizontal mouting may require derating the

drive. See your LEESON representative for more

information



1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Pas de commentaire

Leeson FHP Series Chassis Mount Variable Speed Drives Manuel d'utilisateur Page 25