Leeson Chassis Mount PWM Control: 175292.00 Manuel d'utilisateur télécharger pdf (Page 22)

Startup and shutdown

To start the drive:

1. Turn the speed adjust potentiometer full counterclockwise

(CCW), or set the voltage signal to zero.

2. Apply DC voltage input.

3. Slowly advance the speed adjust potentiometer clockwise (CW),

or increase the voltage signal. The motor slowly accelerates as

the potentiometer is turned CW or the voltage signal is

increased. Continue until the desired speed is reached.

4. Remove DC voltage input from the drive to coast the motor to a

stop.

If the motor or drive does not perform as described, disconnect the

DC voltage input immediately. Refer to the Troubleshooting section

(page 33) for further assistance.

Operation

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Pas de commentaire

Leeson Chassis Mount PWM Control: 175292.00 Manuel d'utilisateur Page 22