Leeson SCR Thyristor Motor Control Manuel d'utilisateur télécharger pdf (Page 17)

Installation

SPEEDMASTER™ OPERATION MANUAL

• Use 16–20 AWG wire for speed adjust potentiometer wiring.

Use 14–16 AWG wire for AC line (L1, L2) and motor (A1

and A2) wiring.

Warning

Do not install, remove, or rewire this equipment with power

applied. Failure to heed this warning may result in fire,

explosion, or serious injury.

Circuit potentials are at 115 VAC or 230 VAC above ground.

To prevent the risk of injury or fatality, avoid direct contact

with the printed circuit board or with circuit elements.

Do not disconnect any of the motor leads from the drive

unless power is removed or the drive is disabled. Opening

any one motor lead may destroy the drive.



Ꮨ

Wiring

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Pas de commentaire

Leeson SCR Thyristor Motor Control Manuel d'utilisateur Page 17